C user control not updating who is kenny anderson dating

You create new controls in markup or the designer and – they don’t show up in your code.

Even though you know the control is defined on the page you’re in red squiggly hell: So now comes the dance: You’re trying to open the markup editor, make some changes. Open the designer, move something, compile try again… The problem here is that the designer file doesn’t get re-generated if you have some sort of layout error in the page.

The user control tag becomes the focus of the error after pasting it onto the parent page, rather then the real problem, because yet again, the designer reference has not been created.

This one is also the main reason when you try to type the tag for the user control and the tagprefix doesn't list in the intellisence.

All of this also applies to full site WAP conversions.

If pages have errors in them that causes the markup to not compile properly mostly due to naming conflicts or full markup failures you can use this same process to fix pages – one at a time if necessary.

The most common scenario for me is when I paste code in from another page.

For example I have a nearly standard header that I use on some pages that contain common toolbar buttons.

BTW, if you get the General Exception Failure dialog you may not be completely screwed either.

I’ve never converted a site to WAP that just worked – usually there are a few oddball pages that require manual ‘intervention’.

This is a nasty problem but also one that is to a degree self-inflicted.

Raise your hand if this has happened to you (i know it has to me a LOT of times recently): You’re working on a Web Application Project (WAP) page in markup and you paste in some code from another page.

All of a sudden you notice that the page’s generated control definitions (in the .file) no longer update.

Leave a Reply